BILLBOARD
PRINTING
With the Billboarder Framing
SystemTM
FREE
SHIPPING!
(FedEx Ground, contiguous USA)
Billboard Design starting at
$297
|
It's simple. The patent-pending Billboarder Framing
System™ comes in 8-foot lengths. Each 8-foot length comes in two pieces; the base plate and
the cap. Self-tapping screws and compression rubber gaskets are also included. Using the
long screws provided, you attach the base plate to the truck or interior or exterior wall.
You insert the compression rubber gaskets into the gasket trap of the base plate; you only
need to insert the gaskets the first time you install the base plate, not every time you
change the banner. You temporarily tape the banner to the base plate with
super-easy-to-remove duct tape. You hook the anodized capping plate onto the outside edge
of the base plate, and screw the cap to the base plate using the short screws provided. The
compression rubber gaskets compresses the banner against the capping plate, and holds the
whole banner securely. The short screws bring the inside edge capping plate completely down
to the wall, tightening the banner. You're done with your initial installation!
Changing banners is easy,
and a major feature of the Billboarder Framing System. Just remove the capping plate, undo
the duct tape by pulling the banner off, roll up the old banner for future reuse, and
repeat the process above to install your new banner!
|
Style
Color Front, No Back
Sizes
8" x
?
Price
Minimum Order: 1
|
Quantity
|
1
|
2-3
|
4-9
|
10-
14
|
15+
|
|
Pricefor
Each 8' Length
|
$76.00
($9.50
per liner foot)
|
$68.00
($8.50
per liner foot)
|
$60.00
($7.50
per liner foot)
|
$52.00
($6.50
per liner foot)
|
$48.00
($6.00
per liner foot)
|
Prices subject to change without
notice.
Intallation
Instructions
| 
